Energy Saver gas condensate

In the traditional boiler, the fuel combustion in the boiler, the flue gas temperature is relatively high, the water vapor in the flue gas still in the gaseous state, would take a lot of heat.In all types of fossil fuels, the hydrogen gas content of the highest quality of the percentage of hydrogen is about 20% to 25%, the smoke contains a large number of water vapor, it was estimated that 1 square meter burning natural gas to generate steam Paper for the heat away 4000KJ, about the high heat of 10%.

Flue gas condensing heat recovery unit, the use of low-temperature water or air-cooled flue gas, flue gas temperature to achieve near the heat exchanger surface area, water vapor condensation in the flue gas, flue gas at the same time to achieve the release of sensible heat and latent heat of condensation of water vapor release, and the heat exchanger absorbs heat water or air to be heated, to achieve energy recovery, increase the boiler thermal efficiency.

Boiler thermal efficiency: 1NM3 the production of natural gas combustion flue gas is about the theory 10.3NM3 (about 12.5KG). To excess air ratio of 1.3 as an example, have a smoke 14NM3 (about 16.6KG).Flue gas temperature from 200 degrees to 70 degrees lower, sensible heat released about the physical 1600KJ, the rate of water vapor condensation from 50% to release the latent heat of vaporization of about 1850KJ, total heat release 3450KJ, low natural gas is about 10% of heat, if the check 80 % of flue gas entering the heat recovery unit can increase the utilization of geothermal energy for more than 8 percent, natural gas fuel saved nearly 10%.

Split layout, installation takes many forms, flexible and reliable

Spiral fin tube surface as the heat, heat exchanger efficiency, adequate heating surface, flue gas side of the system of small negative force to meet the general requirements of the burner

Condensation heat transfer surface using stainless steel materials, to ensure that the service life.